Box(ing) day

Box(ing) day

And then the day finally was there that everything lined up.

Three days to receive the box we bought earlier to place it on our frame.

Occasionally after work, we would drive by our box to use our battery tools to detach it from the truck where it was mounted on.

After attempting to use large tools, verifying the measurements, cutting the frame, and finally cutting the bolts, the box was released from the chassis.

Next plan was using several stacks of pallets on each corner where we could rest the box on, pull the truck out under(engine was seized) and put our truck under the box and mount it for now to get it home.

Lets first check if the box is indeed loose from its frame.

That happened to be the case, so a couple of blocks were put between the frame and the box.

Next we'll pull the truck out...

First attempt with our car (Volvo 4x4) didn't work. Second attempt, with our truck with locked differential, took off the bumper...

Third attempt, with the tow strap deeper in the frame, dug our truck in the gravel...

The neighboring company informed us about a nearby neighbor who manages Sea containers and owned a large forklift. This neighbor had assisted them before, so perhaps he would be willing to help us as well. And that he would:

He took the truck out of it's line up,

so he could lift the box from the side,

and put the box on our frame.

With a little finetuning the box was placed on our frame,

then put the truck back where it came from, but without the box of course.

Securing the box on our chassis was next:

That was the initial plan, but I encountered a storage system for the walking bridge in the middle of the box frame that needed to be removed first, otherwise the long bolts needed to mount from box to underneath our frame wouldn't be long enough.

After doing so, the final bolt still wouldn’t fit due to an obstruction from a ladder storage system, which I also had to remove.

Finally, I could tighten the last bolt as well.

Walking around the truck I found the passenger side wheel a little too close to the edge. Once I trimmed a small portion from the edge, I was confident it wouldn't cause any harm.

So, here we are now:

Next step, Align and mount the box properly. But that will be for a next blog, as we need to prepare more then only doing so.

See you next blog.